D-Link DGS-3620-52T CLI Guide - Page 861
show poe ports
View all D-Link DGS-3620-52T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 861 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide power_limit - (Optional) Specifies the power budget of the PoE system. - Enter the power budger limit value here. This value must be between 37 and 760. power_disconnect_method - (Optional) Specifies the disconnection method that will be used when the power budget is running out. When the system attempts to supply power to a new port, if the power budget is insufficient to do this, the PoE controller will initiate a port disconnection procedure to prevent overloading the power supply. The controller uses one of the following two ways to perform the disconnection procedure. deny_next_port - Specifies the port with the maximum port number will be denied regardless of its priority. If the disconnect method is set to deny the next port, the power provision will not utilize the system's maximum power. There is a 19W safety margin. That is, when the system has only 19W remaining, this power cannot be utilized. deny_low_priority_port - If there are ports that supplied power, that have a priority lower than the new port, the port with the lowest priority will be disconnected. This process will stop until enough power is released for the new port. Note that if the disconnect method is set to deny low priority port, then the power provision can utilize the system's maximum power. legacy_pd - (Optional) Specifies the legacy PDs detection status. enable - Specifies that the legacy PDs detection status will be enabled. disable - Specifies that the legacy PDs detection status will be disabled and can't detect the legacy PDs signal. Restrictions Only Administrator, Operator and Power-User level users can issue this command. Example To configure the PoE system-wise setting: DGS-3620-28SC:admin#config poe system power_limit 250 power_disconnect_method deny_low_priority_port Command: config poe system power_limit 250 power_disconnect_method deny_low_priority_port Success. DGS-3620-28SC:admin# 77-3 show poe ports Description This command is used to display the settings and actual values of the PoE port. Note: This command is only available to Switches in the DGS-3620 Series that support Power over Ethernet. Format show poe ports {} Parameters ports - (Optional) Specifies the list of ports to be displayed here. - Enter the list of ports, used for the display, here. 856