D-Link DGS-3620-52T CLI Guide - Page 820
config pim-ssm
View all D-Link DGS-3620-52T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 820 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide Example To list all the RPs of the registered checksum, including the data: DGS-3620-28SC:admin# show pim register_checksum_include_data_rp_list Command: show pim register_checksum_include_data_rp_list PIM Register Checksum Include Data RP Address 24.0.0.0 24.1.2.3 Total Entries: 2 DGS-3620-28SC:admin# 73-21 config pim-ssm Description This command is used to enable the SSM (Source-Specific Multicast) service model in PIM-SM on the switch. The PIM-SSM function will take active only when SSM service model and PIM-SM state both enabled. Format config pim-ssm {state [enable | disable] | group_range [default | ]} (1) Parameters state - (Optional) Specifies to enable or disable the SSM service model on the Switch. enable - Specifies that the SSM service model will be enabled. disable - Specifies that the SSM service model will be disabled. group_range - (Optional) Specifies the group address range for the SSM service in IPv4. default - The default indicates that the group address range is 232.0.0.0/8. - Enter the group address range for the SSM service here. Restrictions Only Administrator, Operator and Power-User level users can issue this command. Example To configure PIM-SSM state and group range: DGS-3620-28SC:admin# config pim-ssm state enable group_range default Command: config pim-ssm state enable group_range default Success. DGS-3620-28SC:admin# 815