D-Link DGS-3620-52T CLI Guide - Page 176
config bgp neighbor timer
View all D-Link DGS-3620-52T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 176 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide enable - Specifies that the allow AS-in option will be enabled. - Enter the allow AS-in value used here. This value must be between 1 and 10. disable - Specifies that the allow AS-in option will be disabled. default_originate - (Optional) Specifies to enable or disable the default originate function. By default, this setting is disabled. enable - Specifies that the default originate function will be enabled. route_map - Specifies the route map name. - Enter the route map name here. This name can be up to 16 characters long. disable - Specifies that the default originate function will be disabled. Restrictions Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only Command) Example This example shows how to configure the EBGP multi-hop to 2: DGS-3620-28SC:admin# config bgp neighbor general 10.100.200.1 ebgp_multihop 2 Command: config bgp neighbor general 10.100.200.1 ebgp_multihop 2 Success. DGS-3620-28SC:admin# 12-25 config bgp neighbor timer Description This command is used to configure the BGP neighbor's timer attribute. advertisement_interval: If an advertised route is flapping, this usually occurs when an interface is unstable, a lot of UPDATE and WITHDRAWN messages will be sent. One method to control the flooding of these messages is to set a minimum advertisement interval. Format config bgp neighbor timer [ | peer_group ] {advertisement_interval [ | default] | [keepalive holdtime | default_keepalive_holdtime] | as_origination_interval [ | default] | connect [ | default]}(1) Parameters - Specifies the IP address of the neighbor to be configured. peer_group - Specifies the peer group to be configured. - Enter the peer group name here. This name can be up to 16 characters long. advertisement_interval - (Optional) It specifies the interval at which the BGP process sends update messages to its peer. If this value is set to zero, the update or withdrawn message will be sent immediately. The default value for IBGP peers is 5 seconds and for EBGP peers it is 30 seconds. When it is specified to default, the neighbor specific advertisement interval setting will be returned to the default setting. 171