D-Link DGS-3620-52T CLI Guide - Page 633
config loopdetect trap
View all D-Link DGS-3620-52T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 633 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide Restrictions None. Example To display the loop detection state of ports 1 to 9 in port-based mode: DGS-3620-28SC:admin#show loopdetect ports 1-9 Command: show loopdetect ports 1-9 Port Loopdetect State Loop Status 1 Enabled Normal 2 Enabled Normal 3 Enabled Normal 4 Enabled Normal 5 Enabled Loop! 6 Enabled Normal 7 Enabled Loop! 8 Enabled Normal 9 Enabled Normal DGS-3620-28SC:admin# To display loop detection state of ports 1 to 9 under VLAN-based mode: DGS-3620-28SC:admin#show loopdetect ports 1-9 Command: show loopdetect ports 1-9 Port Loopdetect State Loop VLAN 1 Enabled None 2 Enabled None 3 Enabled None 4 Enabled None 5 Enabled 2 6 Enabled None 7 Enabled 2 8 Enabled None 9 Enabled None DGS-3620-28SC:admin# 54-7 config loopdetect trap Description This command is used to configure the trap mode. A loop detected trap is sent when the loop condition is detected and a loop cleared trap is sent when the loop condition is cleared. 628