D-Link DGS-3620-52T CLI Guide - Page 608
<sec 5-32768>
View all D-Link DGS-3620-52T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 608 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide The TTL will be carried in the LLDPDU packet. The lifetime will be the minimum of 65535 and (message_tx_interval * message_tx_hold_multiplier). On the partner switch, when the time-to-live for a given advertisement expires, the advertised data is deleted from the neighbor switch's MIB. The TX delay is used to change the minimum time (delay-interval) any LLDP port will delay advertising successive LLDP advertisements due to a change in LLDP MIB content. The TX delay defines the minimum interval between sending of LLDP messages due to the constantly changing MIB content. A re-enabled LLDP port will wait for the reinit delay after the last disable command before reinitializing. Format config lldp [message_tx_interval | message_tx_hold_multiplier | tx_delay | reinit_delay ] Parameters message_tx_interval - Specify the message TX interval between consecutive transmissions of LLDP advertisements on any given port. - The range is from 5 to 32768 seconds. The default setting is 30 seconds. message_tx_hold_multiplier - Specify the message TX hold multiplier. - Specify the range is from 2 to 10. The default setting is 4. tx_delay - Specify the TX delay time. - Specify the range is from 1 to 8192 seconds. The default setting is 2 seconds. Note: txDelay should be less than or equal to 0.25 * msgTxInterval. reinit_delay - Specify the reinit delay time. - Specify the range is from 1 to 10 seconds. The default setting is 2 seconds. Restrictions Only Administrator, Operator and Power-User level users can issue this command. Example To change the packet transmission interval: DGS-3620-28SC:admin#config lldp message_tx_interval 30 Command: config lldp message_tx_interval 30 Success. DGS-3620-28SC:admin# To change the multiplier value: DGS-3620-28SC:admin#config lldp message_tx_hold_multiplier 3 Command: config lldp message_tx_hold_multiplier 3 Success. DGS-3620-28SC:admin# To configure the delay-interval interval: 603