D-Link DGS-3620-52T CLI Guide - Page 869

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide Example To specify the transport protocol of PTP as IEEE802.3 Ethernet frames: DGS-3620-28SC:admin# config ptp transport protocol ethernet Command: config ptp transport protocol ethernet Success. DGS-3620-28SC:admin# 79-5 config ptp clock domain_number Description This command is used to configure the PTP clock common attribute of the domain number. The domain number is used to identify the PTP domain that the PTP clock is working on. If the domain number of the received PTP message is not identical to the domain number of the local device, the PTP message shall be forwarded according to the multicast filtering configuration. Format config ptp clock domain_number {unit } {domain_name } Parameters domain_number - Specifies the domain attribute of the local clock. All PTP messages, data sets, state machines, and all other PTP entities are always associated with a particular domain number. - Enter the domain number used here. This value must be between 0 and 127. The default value is 0. unit - (Optional) specifies the domain number for a specified unit. If not specified, the domain configurations applies to the local unit. If the unit is not present, the configuration is ignored. - Enter the unit ID used here. This value must be between 1 and 12. domain_name - (Optional) Specifies the domain name for a specified domain number. - Enter the domain name used here. This name can be up to 32 characters long. Restrictions Only Administrator, Operator and Power-User level users can issue this command. Example To configure the domain number of the PTP clock as 1 and assign a domain name of internal_domain on the local unit, when the stacking mode is disabled: DGS-3620-28SC:admin# config ptp clock domain_number 1 domain_name internal_domain Command: config ptp clock domain_number 1 domain_name internal_domain Success. DGS-3620-28SC:admin# 864