D-Link DGS-3620-52T CLI Guide - Page 424
show erps
View all D-Link DGS-3620-52T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 424 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide Parameters trap - Specifies to enable or disable the ERPS trap state. enable - Enter enable to enable the trap state. disable - Enter disable to disable the trap state. The default value is disabled. Restrictions Only Administrator, Operator and Power-User level users can issue this command. Example To configure the trap state of the ERPS: DGS-3620-28SC:admin# config erps trap enable Command: config erps trap enable Success. DGS-3620-28SC:admin# 31-8 show erps Description This command is used to display ERPS configuration and operation information. The port state of the ring port may be as Forwarding, Blocking, or Signal Fail. Forwarding indicates that traffic is able to be forwarded. Blocking indicates that traffic is blocked by ERPS and a signal failure is not detected on the port. Signal Fail indicates that a signal failure is detected on the port and traffic is blocked by ERPS. Format show erps {raps_vlan {sub_ring}} Parameters raps_vlan - Specifies the R-APS VLAN. - Enter the R-APS VLAN ID used here. sub_ring - Display the sub-ring configuration information. Restrictions None. Example To display ERPS information: 419