D-Link DGS-3620-52T CLI Guide - Page 838

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide Example To show the entire active RP information: DGS-3620-28SC:admin# show pim6 rpset Command: show pim6 rpset Bootstrap Router: 2008::1 PIM6 RP-Set Table Group : FF3D::/64 RP Address : 2008::10F2 Hold Time : 210 sec Expired Time : 196 sec Type : Dynamic Group : FF3D::/64 RP Address : 3008::2DEF Override Dynamic : False Type : Static Total Entries: 2 DGS-3620-28SC:admin# 74-19 config pim6 register_checksum_calculate Description This command is used to decide the checksum in register packet will include the data portion or not. As defined in RFC 4601, the checksum for Registers is done only on the first 8 bytes of the packet, including the PIM header and the next 4 bytes, excluding the data packet portion. Some earlier PIM6-SM routers will calculate checksum for register packet including data portion. This configuration makes our routers communicate with those earlier routers smoothly. The default set is not including data portion. Format config pim6 register_checksum_calculate [include_data | not_include_data] Parameters register_checksum_calculate - Specifies the register packet checksum calculating mechanism. include_data - When calculate the checksum in IPv6 PIM register packet, the data portion will be included. not_include_data - When calculate the checksum in IPv6 PIM register packet, the data portion won't be included. Restrictions Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only Command) 833