D-Link DGS-3620-52T CLI Guide - Page 935

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide 200 maxheadersize 120 Command: create sflow flow_sampler ports 1 analyzer_server_id 1 rate 200 maxheadersize 120 Success. DGS-3620-28SC:admin# 87-5 config sflow flow_sampler ports Description This command is used to configure the sFlow flow sampler parameters. Format config sflow flow_sampler ports [ | all] {rate | tx_rate | maxheadersize }(1) Parameters - Specify the list of ports to be configured. all - Specify to configure all ports. rate - Specify the sampling rate for packet sampling. - Specify the sampling rate for packet sampling. The configured rate value multiplied by 256 is the actual rate. For example, if the rate is 20, the actual rate 5120. One packet will be sampled from every 5120 packets. If set to 0, the sampler is disabled. If the rate is not specified, its default value is 0. tx_rate - Specifies the transmit rate. - Enter the transmit rate used here. This value must be between 0 and 65535. maxheadersize - Specify the maximum number of leading bytes in the packet which has been sampled that will be encapsulated and forwarded to the server. - Specify the maximum number of leading bytes in the packet which has been sampled that will be encapsulated and forwarded to the server. If not specified, the default value is 128. Restrictions Only Administrator and Operator-level users can issue this command. Example To configure the sFlow flow sampler parameters: DGS-3620-28SC:admin#config sflow flow_sampler ports all rate 1 Command: config sflow flow_sampler ports all rate 1 Success. DGS-3620-28SC:admin# 930