D-Link DGS-3620-52T CLI Guide - Page 125
Restrictions
View all D-Link DGS-3620-52T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 125 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide permit - Permit the packet. replace_dscp - (Optional) Changes the DSCP of the packet. - Enter the DSCP replace value here. This value must be between 0 and 63. drop - Drops the packet. counter - (Optional) Specifies the ACL counter. This is optional. The default is "disable". The resource may be limited so that a counter cannot be turned on. Counters will be cleared when the function is disabled. enable - Specifies that the ACL counter parameter will be enabled. disable - Specifies that the ACL counter parameter will be disabled. sr_tcm - Specify the "single rate three color mode". cir - Specifies the single rate three color mode used. - Enter the single rate three color mode value here. This value must be between 0 and 1048576. cbs - Specify the "committed burst size". The unit is Kbytes. - Enter the committed burst size value here. This value must be between 0 and 131072. ebs - Specify the "Excess Burst Size". The unit is Kbytes. - Enter the excess burst size value here. This value must be between 0 and 131072. color_blind - (Optional) Specify the meter mode to be color-blind. The default is color-blind mode. color_aware - (Optional) Specify the meter mode to be color-aware. When this code is specified, user could set the "in-coming packet color" by using command "config color_aware". The final color of packet is determined by the initial color of packet and the metering result. conform - (Optional) Specify the action when packet is in "green color". permit - (Optional) Permit the packet. replace_dscp - Changes the DSCP of the packet. - Enter the replace DSCP value here. This value must be between 0 and 63. counter - (Optional) Specifies the ACL counter. This is optional. The default is "disable". The resource may be limited so that a counter cannot be turned on. Counters will be cleared when the function is disabled. enable - Specifies that the ACL counter parameter will be enabled. disable - Specifies that the ACL counter parameter will be disabled. exceed - Specify the action when packet is in "yellow color". permit - Permit the packet. replace_dscp - (Optional) Changes the DSCP of the packet. - Enter the DSCP replace value here. This value must be between 0 and 63. drop - Drops the packet. counter - (Optional) Specifies the ACL counter. This is optional. The default is "disable". The resource may be limited so that a counter cannot be turned on. Counters will be cleared when the function is disabled. enable - Specifies that the ACL counter parameter will be enabled. disable - Specifies that the ACL counter parameter will be disabled. violate - Specify the action when packet is in "red color". permit - Permit the packet. replace_dscp - (Optional) Changes the DSCP of the packet. - Enter the DSCP replace value here. This value must be between 0 and 63. drop - Drops the packet. counter - (Optional) Specifies the ACL counter. This is optional. The default is "disable". The resource may be limited so that a counter cannot be turned on. Counters will be cleared when the function is disabled. enable - Specifies that the ACL counter parameter will be enabled. disable - Specifies that the ACL counter parameter will be disabled. delete - Delete the specified "flow_meter". Restrictions Only Administrator, Operator and Power-User level users can issue this command. 120