D-Link DGS-3620-52T CLI Guide - Page 825

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide To show the detailed info of the PIM6 protocol concerned parameters on the interface "System": DGS-3620-28SC:admin# show pim6 ipif System Command: show pim6 ipif System Interface Name Interface Link-Local Address PIM6 Mode State Designated Router Designated Router Priority Designated Router Priority Enabled Hello Interval Triggered Hello Interval Hello Holdtime Join Prune Interval Join Prune Holdtime LAN Delay Enabled Propagation Delay Override Interval Effective Propagation Delay Effective Override Interval Join Suppression Enabled Bidirectional Capable BSR Domain Border Stub Interface : System : FE80::207:E9FF:81D : SM : Enabled : FE80::207:E9FF:FACC : 1 : True : 30 sec : 5 sec : 105 sec : 60 sec : 210 sec : True : 1 sec : 3 sec : 1 sec : 3 sec : True : False : Disabled : Disabled DGS-3620-28SC:admin# 74-3 config pim6 cbsr Description This command is used to set the parameters concerned with the candidate bootstrap router. Format config pim6 cbsr {ipif state [enable | disable] | priority | hash_masklen } (1) Parameters ipif - (Optional) Specifies the IP interface used in this configuration. - Enter the IP interface name used here. This name can be up to 12 characters long. state - (Optional) Specifies whether the input interface can be a C-BSR or not. enable - Specifies that the input interface will be a C-BSR. disable - Specifies that the input interface will not be a C-BSR. priority - (Optional) Specifies the C-BSR priority value. - Enter the C-BSR priority value here. This value must be between 0 and 255. The default value is 64. hash_masklen - (Optional) Specifies the length (in bits) of the mask. It makes use of a hash function for the case where a group range has multiple RPs with the same priority. - Enter the length of the mask value here. This value must be between 0 and 820