D-Link DGS-3620-52T CLI Guide - Page 811
config pim crp
View all D-Link DGS-3620-52T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 811 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide C-BSR Hash Mask Len C-BSR Bootstrap Period : 30 : 60 Interface IP Address Priority System 11.52.33.3/8 -1 (Disabled) Total Entries: 1 DGS-3620-28SC:admin# 73-8 config pim crp Description This command is used to set the candidate rendezvous point (RP) related parameters. Format config pim crp {holdtime | priority | wildcard_prefix_cnt [0 | 1]} (1) Parameters holdtime - (Optional) This field is used to set the time Candidate RP (CRP) advertisements are valid on the PIM-SM enabled network. If CRP advertisements are not received by the BSR within this time frame, the CRP is removed from the list of candidates. An entry of 0 will send out one advertisement that states to the BSR that it should be immediately removed from CRP status on the PIM-SM network. - Enter the hold time for the RP here. This value must be between 0 and 255. The default value is 150 seconds. priority - (Optional) Specifies the priority used for RP election. This priority value will be included in the router's CRP advertisements. A lower value means a higher priority, yet, if there is a tie for the highest priority, the router having the higher IP address will become the RP. - Enter the priority value used here. This value must be between 0 and 255. The default value is 192. wildcard_prefix_cnt - (Optional) Specifies the Prefix Count value of the wildcard address (224.0.0.0/24) to be choosed. The default vaule is 0. 0 - Specifies that the wildcard prefix count value will be set to 0. 1 - Specifies that the wildcard prefix count value will be set to 1. Restrictions Only Administrator, Operator and Power-User level users can issue this command. Example To configure the candidate rendezvous point (RP) holdtime, priority and wildcard prefix count: DGS-3620-28SC:admin# config pim crp holdtime 150 priority 192 wildcard_prefix_cnt 0 Command: config pim crp holdtime 150 priority 192 wildcard_prefix_cnt 0 Success. 806