D-Link DGS-3620-52T CLI Guide - Page 157
config bgp synchronization, config bgp enforce_first_as
View all D-Link DGS-3620-52T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 157 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide Example To configure the BGP process's router ID: DGS-3620-28SC:admin# config bgp router_id 10.10.10.1 Command: config bgp router_id 10.10.10.1 Success DGS-3620-28SC:admin# 12-6 config bgp synchronization Description This command is used to configure the BGP synchronization ability. Usually, a BGP speaker does not advertise a route to an external neighbor unless that route is local or exists in the IGP. By default, synchronization between BGP and the IGP is turned off to allow the BGP to advertise a network route without waiting for route validation from the IGP. This feature allows routers and access servers within an Autonomous System to have the route before BGP makes it available to other autonomous systems. Format config bgp synchronization [enable | disable] Parameters enable - Specifies to enable synchronization. disable - Specifies to disable synchronization. By default, this setting is disabled. Restrictions Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only Command) Example To enable the BGP process' synchronization ability: DGS-3620-28SC:admin# config bgp synchronization enable Command: config bgp synchronization enable Success DGS-3620-28SC:admin# 12-7 config bgp enforce_first_as Description This command is used to enforce the neighbor's AS as the first AS in the AS list. 152