D-Link DGS-3620-52T CLI Guide - Page 205

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide 12-53 config bgp scan_timer Description This command is used to configure the BGP scan timer value. BGP will check the next hop whether it is reachable from the BGP route before the timer expires. Format config bgp scan_timer [ | default] Parameters - Set the BGP scan timer value from 5 to 60 seconds. Default is 60 seconds default - Set the BGP scan timer to the default value. Restrictions Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only Command) Example This example configures the BGP scan timer to 30 seconds: DGS-3620-28SC:admin# config bgp scan_timer 30 Command: config bgp scan_timer 30 Success. DGS-3620-28SC:admin# 12-54 config bgp aggregate_next_hop_check Description This command is used to configure the BGP aggregated routes' next hop check. Only the routes with the same next hop attribute can be aggregated if the BGP aggregate next hop check is enabled. Format config bgp aggregate_next_hop_check [enable | disable] Parameters enable - Specifies that the BGP aggregate next hop check will be enabled. disable - Specifies that the BGP aggregate next hop check will be disabled. Restrictions Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only Command) 200