D-Link DGS-3620-52T CLI Guide - Page 787
show ospfv3 aggregation
View all D-Link DGS-3620-52T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 787 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide Format config ospfv3 aggregation advertise [enable | disable] Parameters - Specifies the OSPFv3 area's ID. It is a 32-bit number in the form of an IPv4 address that uniquely identifies the OSPFv3 area in the OSPFv3 domain. - Specifies the IPv6 network address of the aggregation. advertise - Specifies whether the OSPFv3 ABR will use this aggregation to aggregate the intra- area routes or not. enable - Specifies that the OSPFv3 ABR will use this aggregation to aggregate the intra-area routes when it advertises these routes to another area. disable - Specifies that the OSPFv3 ABR will not use this aggregation to aggregate the intra- area routes when it advertises these routes to another area. Restrictions Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only Command) Example To configure an OSPFv3 area aggregation: DGS-3620-28SC:admin# config ospfv3 aggregation 2.2.2.2 2000::/16 advertise disable Command: config ospfv3 aggregation 2.2.2.2 2000::/16 advertise disable Success. DGS-3620-28SC:admin# 70-12 show ospfv3 aggregation Description This command is used to display OSPFv3 area aggregation configurations. Format show ospfv3 aggregation {} Parameters - (Optional) Specifies the OSPFv3 area's ID. It is a 32-bit number in the form of an IPv4 address that uniquely identifies the OSPFv3 area in the OSPFv3 domain. Restrictions None. (EI Mode Only Command) 782