D-Link DGS-3620-52T CLI Guide - Page 606
LLDP Commands
View all D-Link DGS-3620-52T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 606 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide Chapter 53 LLDP Commands enable lldp disable lldp config lldp [message_tx_interval | message_tx_hold_multiplier | tx_delay | reinit_delay ] show lldp config lldp forward_message [enable | disable] config lldp notification_interval config lldp ports [ | all] [notification [enable | disable] | admin_status [tx_only | rx_only | tx_and_rx | disable] | mgt_addr [ipv4 | ipv6 ] [enable | disable] | basic_tlvs [{all} | {port_description | system_name | system_description | system_capabilities}] [enable | disable] | dot1_tlv_pvid [enable | disable] | dot1_tlv_protocol_vid [vlan [all | ] | vlanid ] [enable | disable] | dot1_tlv_vlan_name [vlan [all | ] | vlanid ] [enable | disable] | dot1_tlv_protocol_identity [all | {eapol | lacp | gvrp | stp}] [enable | disable] | dot3_tlvs [{all} | {mac_phy_configuration_status | link_aggregation | power_via_mdi | maximum_frame_size}] [enable | disable]] show lldp ports {} config lldp_med fast_start repeat_count config lldp_med log state [enable | disable] config lldp_med notification topo_change ports [ | all] state [enable | disable] config lldp_med ports [ | all] med_transmit_capabilities [all | {capabilities | network_policy | power_pse | inventory}(1)] state [enable | disable] show lldp_med ports {} show lldp_med show lldp_med local_ports {} show lldp_med remote_ports {} show lldp local_ports {} {mode [brief | normal | detailed]} show lldp mgt_addr {[ipv4 | ipv6 ]} show lldp remote_ports {} {mode [brief | normal | detailed]} show lldp statistics show lldp statistics ports {} 53-1 enable lldp Description This command is used to enable LLDP. This is a global control for the LLDP function. When this function is enabled, the switch can start to transmit LLDP packets and receive and process the LLDP packets. The specific function of each port will depend on the per port LLDP setting. For the advertisement of LLDP packets, the switch announces the information to its neighbor through ports. For the receiving of LLDP packets, the switch will learn the information from the LLDP packets advertised from the neighbor in the neighbor table.The default state for LLDP is disabled. Format enable lldp Parameters None. 601