D-Link DGS-3620-52T CLI Guide - Page 532
config ipv6 nd ns ipif
View all D-Link DGS-3620-52T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 532 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide - Specify the IPv6 address static - Specify to display the IPv6 static neighbor cache entries. dynamic - Specify to display the IPv6 dynamic entries. all - Specify to display all IPv6 addresses, static and dynamic. hardware - (Optional) Specify to display all the neighbor cache entries which were written into the hardware table. Restrictions None. Example To display all neighbor cache entries for the IP interface "System": DGS-3620-28SC:admin#show ipv6 neighbor_cache ipif System all Command: show ipv6 neighbor_cache ipif System all FE80::215:72FF:FE36:104 MAC Address : 00-15-72-36-01-04 Interface : System State: Reachable Port : 1:21 VID : 1 Total Entries: 1 DGS-3620-28SC:admin# 45-4 config ipv6 nd ns ipif Description This command is used to configure the NS retransmit time of a specified interface. Format config ipv6 nd ns ipif retrans_time Parameters - Specify the name of the interface. The maximum length is 12 characters. retrans_time - Specify the neighbor solicitation's retransmit timer in milliseconds. It has the same value as ra retrans_time in the config ipv6 nd ra command. If one is configured, the other will change too. - Specify the neighbor solicitation's retransmit timer in milliseconds. It has the same value as ra retrans_time in the config ipv6 nd ra command. If one is configured, the other will change too. Specify a time between 0 and 4294967295 milliseconds. Restrictions Only Administrator, Operator and Power-User level users can issue this command. 527