D-Link DGS-3620-52T CLI Guide - Page 898

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide 81-9 config 802.1p user_priority Description This command is used to configure the way by which the switch will map an incoming packet, based on its 802.1p user priority, to one of the eight available hardware priority queues on the switch. The switch's default is to map the following incoming 802.1p user priority values to the eight hardware priority queues. The suggested mapping is shown in the following table. Users can change this mapping by specifying the 802.1p user priority to assign to the . Priority in Frames Priority Queue of ASIC Remark 0 2 Mid-Low 1 0 Lowest 2 1 Lowest 3 3 Mid-Low 4 4 Mid-High 5 5 Mid-High 6 6 Highest 7 7 Highest Format config 802.1p user_priority {ports [ | all]} Parameters ports - (Optional) Specifies that port used for this configuration. portlist - Specifies the range of ports to be configured. all - Specifies that all the ports will be used for this configuration. - Specify the 802.1p user priority to associate with the (the number of the hardware queue). - Specify the number of the switch's hardware priority queue. The switch has eight hardware priority queues available. They are numbered between 0 (the lowest priority) and 7 (the highest priority). Restrictions Only Administrator, Operator and Power-User level users can issue this command. Example To configure an 802.1p user priority of 1 map to class ID of 3: DGS-3620-28SC:admin#config 802.1p user_priority 1 3 Command: config 802.1p user_priority 1 3 Success. DGS-3620-28SC:admin# 893