D-Link DGS-3620-52T CLI Guide - Page 1085
config gvrp
View all D-Link DGS-3620-52T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1085 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide Restrictions None. Example To display 802.1q port settings for ports 1 to 3: DGS-3620-28SC:admin#show port_vlan 1-3 Command: show port_vlan 1-3 Port ------- 1 2 3 PVID ---1 1 1 GVRP -------Disabled Disabled Disabled Ingress Checking Enabled Enabled Enabled Acceptable Frame Type All Frames All Frames All Frames Total Entries : 3 DGS-3620-28SC:admin# 106-9 config gvrp Description This command is used to set the GVRP timer's value. Format config gvrp [timer [join | leave | leaveall] | nni_bpdu_addr [dot1d | dot1ad]] Parameters timer - Specify GVRP timer. join - Specify the Join time will be set. The default value is 200 milliseconds. leave - Specify the Leave time will be set. The default value is 600 milliseconds. leaveall - Specify the LeaveAll time. The default value is 10000 milliseconds. - Specify the time value. The value range is 100 to 100000 milliseconds. In addition, the Leave time should greater than 2 Join times and the LeaveAll time should greater than Leave time. nni_bpdu_addr - Determine the BPDU protocol address for GVRP in service provide site. It can use 802.1d GVRP address, or 802.1ad service provider GVRP address. dot1d - Specify a 802.1d GVRP address. dot1ad - Specify a 802.1ad service provider GVRP address. Restrictions Only Administrator, Operator and Power-User level users can issue this command. Example To set the Join time to 200 milliseconds: 1080