D-Link DGS-3620-52T CLI Guide - Page 534
config ipv6 nd ra prefix_option ipif
View all D-Link DGS-3620-52T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 534 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide multicast Router Advertisements from the interface, in seconds. It must be no less than 4 seconds and no greater than 1800 seconds. The default is 600 seconds. - Specify the time between 4 and 1800 seconds. Restrictions Only Administrator, Operator and Power-User level users can issue this command. Example To configure the RA state as enabled and the life_time of the "tiberius" interface to be 1000 seconds: DGS-3620-28SC:admin#config ipv6 nd ra ipif tiberius state enable life_time 1000 Command: config ipv6 nd ra ipif tiberius state enable life_time 1000 Success. DGS-3620-28SC:admin# 45-6 config ipv6 nd ra prefix_option ipif Description This command is used to configure the prefix option for the router advertisement function. Format config ipv6 nd ra prefix_option ipif {preferred_life_time | valid_life_time | on_link_flag [enable | disable] | autonomous_flag [enable | disable]}(1) Parameters - Specify the name of the interface. The maximum length is 12 characters. - Specify the IPv6 network address. preferred_life_time - Specify the number in seconds that an address, based on the specified prefix using the stateless address configuration, remains in preferred state. - Specify the time between 0 and 4294967295 seconds. For an infinite valid lifetime the value can be set to 4294967295. valid_life_time - Specify the number of seconds that an address, based on the specified prefix, using the stateless address configuration, remains valid. - Specify the time between 0 and 4294967295 seconds. For an infinite valid lifetime the value can be set to 4294967295. on_link_flag - Specify to enable or disable the function. enable - Setting this field to enable will denote, within the IPv6 packet, that the IPv6 prefix configured here is assigned to this link-local network. Once traffic has been successfully sent to these nodes with this specific IPv6 prefix, the nodes will be considered reachable on the link-local network. disable - When set to disable, the addresses implied by the specified prefix are not available on the link where the RA message is received. autonomous_flag - Specify to enable or disable the function. enable - Setting this field to enable will denote that this prefix may be used to autoconfigure IPv6 addresses on the link-local network. disable - When set to disable, the specified prefix will not be used to create an autonomous 529