D-Link DGS-3620-52T CLI Guide - Page 827
config pim6 crp, create pim6 crp group
View all D-Link DGS-3620-52T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 827 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide 74-5 config pim6 crp Description This command is used to set the candidate rendezvous point (RP) related parameters. Format config pim6 crp [rp | all] {priority | interval } (1) Parameters rp - Specifies the RP IP interface used. - Enter the RP IP interface name used here. This name can be up to 12 characters long. all - Specifies that all the RP IP interfaces will be used. priority - (Optional) Specifies the RP priority value that will be used in the election process. The lower the value, the higher the priority. - Enter the RP priority value used here. This value must be between 0 and 255. The default value is 192. interval - (Optional) Specifies the C-RP advertisement interval in seconds. - Enter the C-RP advertisement interval value here. This value must be betwee 1 and 16383 seconds. The default value is 60 seconds. Restrictions Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only Command) Example To set the C-RP priority and the interval on the interface "System": DGS-3620-28SC:admin# config pim6 crp rp System priority 60 interval 60 Command: config pim6 crp rp System priority 60 interval 60 Success. DGS-3620-28SC:admin# 74-6 create pim6 crp group Description This command is used to add a multicast group range into a C-RP serve list. Format create pim6 crp group rp Parameters group - Specifies the IPv6 group address range served by the RP. - Enter the IPv6 network address used here. 822