D-Link DGS-3620-52T CLI Guide - Page 907
Q-in-Q Command
View all D-Link DGS-3620-52T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 907 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide Chapter 82 Q-in-Q Command enable qinq disable qinq show qinq config qinq ports [ | all] {role [uni | nni] | missdrop [enable | disable] | outer_tpid | use_inner_priority [enable | disable] | add_inner_tag [ | disable]}(1) config qinq inner_tpid show qinq inner_tpid show qinq ports {} create vlan_translation ports [ | all] [add cvid | replace cvid ] svid {priority } delete vlan_translation ports [ | all] {cvid } show vlan_translation {[ports | cvid ]} 82-1 enable qinq Description This command is used to enable Q-in-Q. When Q-in-Q is enabled, all network port roles will be NNI ports and outer TPID will be set to 0x88A8; all existing static VLANs will run as S-VLAN; all dynamic learned L2 addresses will be cleared; all dynamic registered VLAN entries will be cleared; and GVRP will be disabled. To run GVRP on the switch, the administrator should enable GVRP manually. In Q-in-Q mode, GVRP protocol will employ the reserve address 01-80-C2-00-00-0D. The default setting of Q-in-Q is disabled. Format enable qinq Parameters None. Restrictions Only Administrator, Operator and Power-User level users can issue this command. Example To enable Q-in-Q: DGS-3620-28SC:admin#enable qinq Command: enable qinq Success. DGS-3620-28SC:admin# 902