Netgear XSM4324FS CLI Manual Software Version 12.x - Page 1002
show iscsi sessions, traffic class 2 see the CoS configuration shown below. Because remark is enabled
View all Netgear XSM4324FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1002 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches Command example: The following example enable iSCSI: (NETGEAR Switch)#configure (NETGEAR Switch)(config)#iscsi enable Command example: The following examples shows that iSCSI sessions and connections are established using TCP ports 3260 or 860. Packets sent on detected iSCSI TCP connections are assigned to traffic class 2 (see the CoS configuration shown below). Because remark is enabled, the packets are marked with IEEE 802.1p priority to 5 before transmission. (NETGEAR Switch)#show iscsi iscsi enabled iSCSI vpt is 5, remark Session aging time: 10 min Maximum number of sessions is 192 iSCSI Targets and TCP ports: TCP Port Target IP Address Name 860 Configured Not Configured 3260 Configured Not Configured (NETGEAR Switch)#show classofservice dot1p-mapping User Priority Traffic Class 0 1 1 0 2 0 3 1 4 2 5 2 6 3 6 3 show iscsi sessions This command displays the iSCSI sessions. Default Format Mode If not specified, sessions are displayed in short mode (not detailed). show iscsi sessions [detailed] Privileged EXEC Quality of Service Commands 1002 CLI Command Reference Manual