Netgear XSM4324FS CLI Manual Software Version 12.x - Page 191

M4300 Intelligent Edge Series Fully Managed Stackable Switches show bootvar This command displays the version information and the activation status for the current images on the supplied unit of the stack. If you do not specify a unit number, the command displays image details for all nodes in the stack. The command also displays any text description associated with an image. This command, when used on a standalone system, displays the switch activation status. For a standalone system, the unit parameter is not valid. Format Mode show bootvar [unit] Privileged EXEC filedescr This command associates a given text description with an image and replaces any existing description. The command is executed on all units in a stack. Format Mode filedescr {image1 | image2} text-description Privileged EXEC update bootcode This command updates the bootcode (boot loader) on the switch. The bootcode is read from the active image for subsequent reboots. The unit parameter identifies the member on which this command must be executed. When this parameter is not supplied, the command is executed on all units in a stack. Format Mode update bootcode [unit] Privileged EXEC System Information and Statistics Commands This section describes the commands you use to view information about system features, components, and configurations. show arp switch (system information and statistics commands) This command displays the contents of the Address Resolution Protocol (ARP) table that is associated with the IP address of the switch. This IP address learns only ARP entries that are associated with the management interfaces (network or service ports). ARP entries that are associated with routing interfaces are not listed. Utility Commands 191 CLI Command Reference Manual