Netgear XSM4324FS CLI Manual Software Version 12.x - Page 280
IP Address Conflict Commands
View all Netgear XSM4324FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 280 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches Number of retries 5 Retry timeout period 1500 Name servers (Preference order)... 176.16.1.18 176.16.1.19 DNS Client Source Interface....... (not configured) Configured host name-to-address mapping: Host Addresses accounting.gm.com 176.16.8.8 Host www.stanford.edu Total -------- 72 Elapsed -----3 Type -------- IP Addresses 171.64.14.203 IP Address Conflict Commands The commands in this section help troubleshoot IP address conflicts. ip address-conflict-detect run This command triggers the switch to run active address conflict detection by sending gratuitous ARP packets for IPv4 addresses on the switch. Format Mode ip address-conflict-detect run Global Config show ip address-conflict This command displays the status information corresponding to the last detected address conflict. Format Modes show ip address-conflict Privileged EXEC Term Definition Address Conflict Detection Status Identifies whether the switch has detected an address conflict on any IP address. Last Conflicting IP Address The IP Address that was last detected as conflicting on any interface. Last Conflicting MAC Address The MAC Address of the conflicting host that was last detected on any interface. Time Since Conflict Detected The time in days, hours, minutes and seconds since the last address conflict was detected. Utility Commands 280 CLI Command Reference Manual