Netgear XSM4324FS CLI Manual Software Version 12.x - Page 320

M4300 Intelligent Edge Series Fully Managed Stackable Switches Power Management Commands power auto-rebalance Note: This command applies to switch model M4300-96X only. This command enables the switch to automatically readjust the power allocation to the ports on an APM408P port card if the power budget changes or powered devices (PD) change. If the power budget is insufficient, ports with a lower priority (that is, ports with a higher port number) are automatically shut down and ports with a higher priority (that is, ports with a lower port number) are powered. If a PoE port is shut down, slot priority is also taken into consideration. Lower-numbered slots receive higher priority than higher-numbered slots. For example, slot 1 receives higher priority than slot 2, which, in turn, receives higher priority than slot 3, and so on through slot 6, which receives the lowest slot priority. Default Format Mode Enabled power auto-rebalance Global Config no power auto-rebalance Note: This command applies to switch model M4300-96X only. This command prevents the switch from automatically readjusting the power allocation to the ports on an APM408P port card Format Mode no power auto-rebalance Global Config power redundancy This command enables the N+1 power redundancy feature on a switch with a dual PSU configuration. If this feature is enabled, only one PSU provides 56V PoE power to the unit. If the PSU fails, the redundant PSU seamlessly takes over the supply of 56V PoE power to the unit. If this command is disabled, N+1 is also disabled and both PSUs provide 56V PoE power to the unit at the same time. In this situation, the PoE budget for the unit increases. Utility Commands 320 CLI Command Reference Manual