Netgear XSM4324FS CLI Manual Software Version 12.x - Page 377

M4300 Intelligent Edge Series Fully Managed Stackable Switches 1/1/5 1/1/6 1/1/7 1/1/8 Enable Enable Enable Enable 40G Full 10G Full 10G Full 10G Full Down Enable Detach Enable Detach Enable Detach Enable Enable Disable Enable Disable Enable Disable Enable Disable hardware profile portmode This command configures a 40G QSFP port on the APM402XL port card either in the 4x10G or mode or the 1x40G mode. You can execute this command only on interfaces that support the expandable port feature. Entering the command on any other type of interface yields an error. The configuration that you make to a 40G port or to an expanded 40G port (four 10G ports) is retained whether the port status is attached or detached. However, a configuration change is applied only when the port is in the attached state. For example, if you change the configuration on the four 10G ports with port numbers 5 to 8 and then return the port to a single 40G port with port number 5, the configuration for ports 5 to 8 is retained in the running configuration but is not applied. The configuration is applied only after you expand port 5 again to four 10G ports with port numbers 5 to 8. Similarly, when you change the configuration in 40G mode, the configuration is retained in the running configuration, but is applied only when the port is functioning in 40G mode. The possible values for the mode argument are the following: • 1x40G. Configures the port as a single 40G port. • 4x10G. Configures the port as four 10G ports. Note: This command cannot operate in the interface range mode. Default Format Mode The default mode of QSFP port is 1x40G hardware profile portmode mode Interface Config no hardware profile portmode This command sets the ports on the APM402XL port card to their default mode, that is, to the 1x40G mode. Format Mode no hardware profile portmode Interface Config Switching Commands 377 CLI Command Reference Manual