Netgear XSM4324FS CLI Manual Software Version 12.x - Page 985
Table 15., IPv6 ACL command parameters continued, destination-unreachable
View all Netgear XSM4324FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 985 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches Table 15. IPv6 ACL command parameters (continued) Parameter Description destination-ipv6-prefix/prefix-length | any | host destination-ipv6-address For destination-ipv6-prefix/prefix-length, specify a destination IPv6 source address and prefix length to match for the IPv6 ACL rule. Specifying any implies specifying ::/0 Specifying host destination-ipv6-address implies matching the specified IPv6 address. This destination-ipv6-address argument must be in the form documented in RFC 2373 where the address is specified in hexadecimal using 16-bit values between colons. [dscp dscp] Specifies the dscp value to match for the IPv6 rule. flag [+fin | -fin] [+syn | -syn] [+rst | -rst] [+psh | -psh] [+ack | -ack] [+urg | -urg] [established] Specifies that the IPv6 ACL rule matches on the tcp flags. When + is specified, a match occurs if specified flag is set in the TCP header. When "-" is specified, a match occurs if specified flag is not set in the TCP header. When established is specified, a match occurs if specified either RST or ACK bits are set in the TCP header. Two rules are installed in hardware to when "established" option is specified. This option is visible only if protocol is tcp. [icmp-type icmp-type [icmp-code Note: This option is available only if the protocol is icmpv6. icmp-code] | icmp-message icmp-message] Specifies a match condition for ICMP packets. When icmp-type is specified, IPv6 ACL rule matches on the specified ICMP message type, a number from 0 to 255. When icmp-code is specified, IPv6 ACL rule matches on the specified ICMP message code, a number from 0 to 255. Specifying icmp-message implies both icmp-type and icmp-code are specified. The following icmp-message options are supported: destination-unreachable, echo-reply, echo-request, header, hop-limit, mld-query, mld-reduction, mld-report, nd-na, nd-ns, next-header, no-admin, no-route, packet-too-big, port-unreachable, router-solicitation, router-advertisement, router-renumbering, time-exceeded, and unreachable. The ICMP message is decoded into the corresponding ICMP type and ICMP code within that ICMP type. fragments Specifies that IPv6 ACL rule matches on fragmented IPv6 packets (Packets that have the next header field is set to 44). routing Specifies that IPv6 ACL rule matches on IPv6 packets that have routing extension headers (the next header field is set to 43). log Specifies that this rule is to be logged. Quality of Service Commands 985 CLI Command Reference Manual