Netgear XSM4324FS CLI Manual Software Version 12.x - Page 372

M4300 Intelligent Edge Series Fully Managed Stackable Switches Term Definition Interface unit/slot/port Type If not blank, this field indicates that this port is a special type of port. The possible values are: • Mirror. The port is a monitoring port. For more information, see Port Mirroring Commands on page 521. • PC Mbr. The port is a member of a port-channel (LAG). • Probe. The port is a probe port. Admin Mode The Port control administration state. The port must be enabled in order for it to be allowed into the network. May be enabled or disabled. The factory default is enabled. Admin Status If the Admin Mode indicates that a port is disabled, this field states the reason why the port is disabled. Physical Mode The desired port speed and duplex mode. If auto-negotiation support is selected, then the duplex mode and speed is set from the auto-negotiation process. Note that the maximum capability of the port (full duplex -100M) is advertised. Otherwise, this object determines the port's duplex mode and transmission rate. The factory default is Auto. Physical Status The port speed and duplex mode. Link Status The Link is up or down. Link Trap This object determines whether or not to send a trap when link status changes. The factory default is enabled. LACP Mode LACP is enabled or disabled on this port. Command example: The following example shows output for all ports: (NETGEAR Switch) #show port all Admin Physical Physical Link Link LACP Actor Intf Type Mode Mode Status Status Trap Mode Timeout 0/1 Enable Auto 100 Full Up Enable Enable long 0/2 Enable Auto 100 Full Up Enable Enable long 0/3 Enable Auto Down Enable Enable long 0/4 Enable Auto 100 Full Up Enable Enable long 0/5 Enable Auto 100 Full Up Enable Enable long 0/6 Enable Auto 100 Full Up Enable Enable long 0/7 Enable Auto 100 Full Up Enable Enable long 0/8 Enable Auto 100 Full Up Enable Enable long 1/1 Enable Down Disable N/A N/A 1/2 Enable Down Disable N/A N/A 1/3 Enable Down Disable N/A N/A 1/4 Enable Down Disable N/A N/A 1/5 Enable Down Disable N/A N/A 1/6 Enable Down Disable N/A N/A Switching Commands 372 CLI Command Reference Manual