Netgear XSM4324FS CLI Manual Software Version 12.x - Page 737

M4300 Intelligent Edge Series Fully Managed Stackable Switches no timers pacing flood To revert LSA transmit pacing to the default rate, use the no timers pacing flood command. Format Mode no timers pacing flood OSPFv2 Router Configuration timers pacing lsa-group (OSPF) To adjust how OSPF groups LSAs for periodic refresh, use the timers pacing lsa-group command in OSPFv2 Router Configuration mode. OSPF refreshes self-originated LSAs approximately once every 30 minutes. When OSPF refreshes LSAs, it considers all self-originated LSAs whose age is from 1800 to 1800 plus the pacing group size. Grouping LSAs for refresh allows OSPF to combine refreshed LSAs into a minimal number of LS Update packets. Minimizing the number of Update packets makes LSA distribution more efficient. When OSPF originates a new or changed LSA, it selects a random refresh delay for the LSA. When the refresh delay expires, OSPF refreshes the LSA. By selecting a random refresh delay, OSPF avoids refreshing a large number of LSAs at one time, even if a large number of LSAs are originated at one time. Default Format Mode 60 seconds timers pacing lsa-group seconds OSPFv2 Router Configuration Parameter seconds Description Width of the window in which LSAs are refreshed. The range for the pacing group window is from 10 to 1800 seconds. timers spf Use this command to configure the SPF delay time and hold time. The valid range for both the delay time and hold time parameters is 0-65535 seconds. Default Format Mode delay-time-5 hold-time-10 timers spf delay-time hold-time Router OSPF Config Routing Commands 737 CLI Command Reference Manual