Netgear XSM4324FS CLI Manual Software Version 12.x - Page 449

M4300 Intelligent Edge Series Fully Managed Stackable Switches switchport private-group This command assigns one port or a range of ports to a private group. You specify the private group by either its name or its identifier. The ingress traffic from a port in a private group can be forwarded to other ports either in the same private group or outside the private group but in the same VLAN. By default, a port does not belong to any private group. A port cannot be in more than one private group. To change the membership of a port in a private group, first remove the port from the private group. Format Mode switchport private-group [privategroup-name | privategroup-id] Interface Config no switchport private-group This command removes a port from to a private group. Format Mode no switchport private-group [privategroup-name | privategroup-id] Interface Config private-group name This command creates a private group with a name or an identifier. The name string can be up to 24 bytes of non-blank characters. A total number of 192 of private groups is supported. Therefore, the group identifier can be from 1 to 192. The private-group-id parameter is optional. If you do not specify a group identifier, the identifier is assigned automatically. The optional mode for the group can be either isolated or community. If the private group is in isolated mode, the member port in the group cannot forward its egress traffic to any other members in the same group. By default, the mode for the private group is community mode, allowing each member port to forward traffic to other members in the same group, but not to members in other groups. Format Mode private-group name privategroup-name [private-group-id] [mode {community | isolated}] Global Config no private-group name This command removes a private group. Format Mode no private-group name privategroup-name Global Config Switching Commands 449 CLI Command Reference Manual