Netgear XSM4324FS CLI Manual Software Version 12.x - Page 833

M4300 Intelligent Edge Series Fully Managed Stackable Switches no ipv6 neighbor Removes a static IPv6 neighbor with the given IPv6 address on a routing or host interface. Format Mode no ipv6 neighbor ipv6address {unit/slot/port | vlan vland-id} Global Config ipv6 neighbors dynamicrenew Use this command to automatically renew the IPv6 neighbor entries. Enables/disables the periodic NUD (neighbor unreachability detection) to be run on the existing IPv6 neighbor entries based on the activity of the entries in the hardware. If the setting is disabled, only those entries that are actively used in the hardware are triggered for NUD at the end of STALE timeout of 1200 seconds. If the setting is enabled, periodically every 40 seconds a set of 300 entries are triggered for NUD irrespective of their usage in the hardware. Default Format Mode Disabled ipv6 neighbors dynamicrenew Global Config no ipv6 neighbors dynamicrenew Disables automatic renewing of IPv6 neighbor entries. Format Mode no ipv6 neighbors dynamicrenew Global Config ipv6 nud Use this command to configure Neighbor Unreachability Detection (NUD). NUD verifies that communication with a neighbor exists. Format Mode ipv6 nud {backoff-multiple | max-multicast-solicits | max-unicast-solicits} Global Config Term Definition backoff-multiple Sets the exponential backoff multiple to calculate time outs in NS transmissions during NUD. The value ranges from 1 to 5. 1 is the default. The next timeout value is limited to a maximum value of 60 seconds if the value with exponential backoff calculation is greater than 60 seconds. max-multicast-solici Sets the maximum number of multicast solicits sent during Neighbor Unreachability Detection. The ts value ranges from 3 to 255. 3 is the default. max-unicast-solicits Sets the maximum number of unicast solicits sent during Neighbor Unreachability Detection. The value ranges from 3 to 10. 3 is the default. IPv6 Commands 833 CLI Command Reference Manual