Netgear XSM4324FS CLI Manual Software Version 12.x - Page 77

M4300 Intelligent Edge Series Fully Managed Stackable Switches show telnetcon This command displays the current inbound Telnet settings. In other words, these settings apply to Telnet connections initiated from a remote system to the switch. Format Modes show telnetcon • Privileged EXEC • User EXEC Term Definition Remote Connection Login This object indicates the number of minutes a remote connection session is allowed to remain Timeout (minutes) inactive before being logged off. May be specified as a number from 1 to 160. The factory default is 5. Maximum Number of Remote Connection Sessions This object indicates the number of simultaneous remote connection sessions allowed. The factory default is 5. Allow New Telnet Sessions New Telnet sessions will not be allowed when this field is set to no. The factory default value is yes. Telnet Server Admin Mode States whether the Telnet Server Admin Mode is enabled or disabled. Telnet Server Port The port number on which the Telnet server can detect requests. Secure Shell Commands This section describes the commands you use to configure Secure Shell (SSH) access to the switch. Use SSH to access the switch from a remote management host. Note: The system allows a maximum of 5 SSH sessions. ip ssh Use this command to enable SSH access to the system. (This command is the short form of the ip ssh server enable command.) Default Format Mode disabled ip ssh Privileged EXEC Management Commands 77 CLI Command Reference Manual