Netgear XSM4324FS CLI Manual Software Version 12.x - Page 709
DHCP and BootP Relay Commands
View all Netgear XSM4324FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 709 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches clear ip vrrp interface stats This command clears VRRP statistical information from an interface or a VLAN. The virtual router ID, vrid, is an integer value that ranges from 1 to 255. Format Modes clear ip vrrp interface stats {unit/slot/port vrid} | {vlan vlan-id vrid} Interface Config DHCP and BootP Relay Commands This section describes the commands you use to configure BootP/DHCP Relay on the switch. A DHCP relay agent operates at Layer 3 and forwards DHCP requests and replies between clients and servers when they are not on the same physical subnet. bootpdhcprelay cidoptmode This command enables the circuit ID option mode for BootP/DHCP Relay on the system. Default Format Mode disabled bootpdhcprelay cidoptmode Global Config no bootpdhcprelay cidoptmode This command disables the circuit ID option mode for BootP/DHCP Relay on the system. Format Mode no bootpdhcprelay cidoptmode Global Config bootpdhcprelay maxhopcount This command configures the maximum allowable relay agent hops for BootP/DHCP Relay on the system. The hops parameter has a range of 1 to 16. Default Format Mode 4 bootpdhcprelay maxhopcount hops Global Config Routing Commands 709 CLI Command Reference Manual