Netgear XSM4324FS CLI Manual Software Version 12.x - Page 873
trapflags OSPFv3, trapflags group name, trapflags all
View all Netgear XSM4324FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 873 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches no timers throttle spf This command returns the SPF throttling parameters to the factory default values. Format Mode no timers throttle spf Router OSPFv3 Config trapflags (OSPFv3) Use this command to enable individual OSPF traps, enable a group of trap flags at a time, or enable all the trap flags at a time. The different groups of trapflags, and each group's specific trapflags to enable or disable, are listed in the following table. Table 12. Trapflag groups (OSPFv3) Group errors lsa overflow retransmit state-change Flags • authentication-failure • bad-packet • config-error • virt-authentication-failure • virt-bad-packet • virt-config-error • lsa-maxage • lsa-originate • lsdb-overflow • lsdb-approaching-overflow • packets • virt-packets • if-state-change • neighbor-state-change • virtif-state-change • virtneighbor-state-change • To enable the individual flag, enter the trapflags group name followed by a particular flag. • To enable all the flags in that group, enter trapflags group name followed by all. • To enable all the flags, enter the command as trapflags all. Default disabled IPv6 Commands 873 CLI Command Reference Manual