Netgear XSM4324FS CLI Manual Software Version 12.x - Page 729
capability opaque, clear ip ospf, no auto-cost reference-bandwidth OSPF
View all Netgear XSM4324FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 729 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches Default Format Mode 100 Mbps auto-cost reference-bandwidth mbps Router OSPF Config no auto-cost reference-bandwidth (OSPF) Use this command to set the reference bandwidth to the default value. Format Mode no auto-cost reference-bandwidth Router OSPF Config capability opaque Use this command to enable Opaque Capability on the Router. The information contained in Opaque LSAs may be used directly by OSPF or indirectly by an application wishing to distribute information throughout the OSPF domain. The switch supports the storing and flooding of Opaque LSAs of different scopes. The default value of enabled means that OSPF will forward opaque LSAs by default. If you want to upgrade from a previous release, where the default was disabled, opaque LSA forwarding will be enabled. If you want to disable opaque LSA forwarding, then you should enter the command no capability opaque in OSPF router configuration mode after the software upgrade. Default Format Mode enabled capability opaque Router Config no capability opaque Use this command to disable opaque capability on the router. Format Mode no capability opaque Router Config clear ip ospf Use this command to disable and re-enable OSPF. Format Mode clear ip ospf Privileged EXEC Routing Commands 729 CLI Command Reference Manual