Netgear XSM4324FS CLI Manual Software Version 12.x - Page 776

M4300 Intelligent Edge Series Fully Managed Stackable Switches distance rip This command sets the route preference value of RIP in the router. Lower route preference values are preferred when determining the best route. A route with a preference of 255 cannot be used to forward traffic. The value for the preference argument can be from 1-255. Default Format Mode 15 distance rip preference Router RIP Config no distance rip This command sets the default route preference value of RIP in the router. Format Mode no distance rip Router RIP Config distribute-list out (RIP) This command is used to specify the access list to filter routes received from the source protocol. The value for the access-list argument can be from 1-199. Default Format Mode 0 distribute-list access-list out {ospf | bgp | static | connected} Router RIP Config no distribute-list out This command is used to specify the access list to filter routes received from the source protocol. The value for the access-list argument can be from 1-199. Format Mode no distribute-list access list out {ospf | bgp | static | connected} Router RIP Config ip rip authentication This command sets the RIP version 2 authentication type and key for the interface or range of interfaces. The type of authentication can be either none, simple, or encrypt. If you select simple or encrypt, the key parameter is composed of standard displayable, noncontrol keystrokes from a standard 101/102-key keyboard. The authentication key must be 8 bytes or less if the authentication type is simple. If the type is encrypt, the key can be up to 16 bytes. Unauthenticated interfaces do not need an authentication key. If the type is encrypt, a keyid in the range of 0 and 255 must be specified. The default value for the Routing Commands 776 CLI Command Reference Manual