Netgear XSM4324FS CLI Manual Software Version 12.x - Page 459
dot1x guest-vlan, dot1x initialize, dot1x max-req, no dot1x dynamic-vlan enable
View all Netgear XSM4324FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 459 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches no dot1x dynamic-vlan enable Use this command to prevent the switch from creating VLANs when a RADIUS-assigned VLAN does not exist in the switch. Format Mode no dot1x dynamic-vlan enable Global Config dot1x guest-vlan This command configures VLAN as guest vlan on an interface or a range of interfaces. The command specifies an active VLAN as an IEEE 802.1X guest VLAN. The range is 1 to the maximum VLAN ID supported by the platform. Default Format Mode Disabled dot1x guest-vlan vlan-id Interface Config no dot1x guest-vlan This command disables Guest VLAN on the interface. Default Format Mode Disabled no dot1x guest-vlan Interface Config dot1x initialize This command begins the initialization sequence on the specified port. This command is only valid if the control mode for the specified port is auto or mac-based. If the control mode is not auto or mac-based, an error is returned. Format Mode dot1x initialize unit/slot/port Privileged EXEC dot1x max-req This command sets the maximum number of times the authenticator state machine on an interface or range of interfaces will transmit an EAPOL EAP Request/Identity frame before timing out the supplicant. The count parameter must be in the range 1-10. Default Format Mode 2 dot1x max-req count Interface Config Switching Commands 459 CLI Command Reference Manual