Netgear XSM4324FS CLI Manual Software Version 12.x - Page 1120

M4300 Intelligent Edge Series Fully Managed Stackable Switches Table 54. DiffServ Log Messages Component DiffServ Message diffserv.c 165: diffServRestore Failed to reset DiffServ. Recommend resetting device DiffServ Policy invalid for service intf: policy name, interface x, direction y Cause While attempting to clear the running configuration an error was encountered in removing the current settings. This may lead to an inconsistent state in the system and resetting is advised. The DiffServ policy definition is not compatible with the capabilities of the interface specified. Check the platform release notes for information on configuration limitations. Routing/IPv6 Routing Table 55. DHCP Relay Log Messages Component DHCP relay DHCP relay DHCP relay Message Cause REQUEST hops field more than config value The DHCP relay agent has processed a DHCP request whose HOPS field is larger than the maximum value allowed. The relay agent will not forward a message with a hop count greater than 4. Request's seconds field less than the config value The DHCP relay agent has processed a DHCP request whose SECS field is larger than the configured minimum wait time allowed. processDhcpPacket: invalid DHCP packet type: The DHCP relay agent has processed an invalid %u\n DHCP packet. Such packets are discarded by the relay agent. Table 56. OSPFv2 Log Messages Component OSPFv2 OSPFv2 Message Best route client deregistration failed for OSPF Redist XX_Call() failure in _checkTimers for thread 0x869bcc0 Cause OSPFv2 registers with the IPv4 routing table manager ("RTO") to be notified of best route changes. There are cases where OSPFv2 deregisters more than once, causing the second deregistration to fail. The failure is harmless. An OSPFv2 timer has fired but the message queue that holds the event has filled up. This is normally a fatal error. Switch Software Log Messages 1120 CLI Command Reference Manual