Netgear XSM4324FS CLI Manual Software Version 12.x - Page 659
ip default-gateway, no ip address dhcp, ip address dhcp client-id
View all Netgear XSM4324FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 659 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches no ip address dhcp The no ip address dhcp command releases a leased address and disables DHCPv4 on an interface. The no form of the ip address dhcp client-id command removes the client-id option and also disables the DHCP client on the in-band interface. Format Mode no ip address dhcp [client-id] Interface Config ip default-gateway This command manually configures a default gateway for the switch. Only one default gateway can be configured. If you invoke this command multiple times, each command replaces the previous value. When the system does not have a more specific route to a packet's destination, it sends the packet to the default gateway. The system installs a default IPv4 route with the gateway address as the next hop address. The route preference is 253. A default gateway configured with this command is more preferred than a default gateway learned from a DHCP server. Format Mode ip default-gateway ipaddr Global Config Parameter ipaddr Description The IPv4 address of an attached router. Command example: The following example sets the default gateway to 10.1.1.1: (NETGEAR Switch) #config (NETGEAR Switch) (Config)#ip default-gateway 10.1.1.1 no ip default-gateway This command removes the default gateway address from the configuration. Format Mode no ip default-gateway ipaddr Interface Config Routing Commands 659 CLI Command Reference Manual