Netgear XSM4324FS CLI Manual Software Version 12.x - Page 524
Static MAC Filtering Commands
View all Netgear XSM4324FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 524 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches Term Definition Type Direction in which source port configured for port mirroring.Types are tx for transmitted packets and rx for receiving packets. Src VLAN All member ports of this VLAN are mirrored. If the source VLAN is not configured, this field is blank. Ref. Port This port carries all the mirrored traffic at the source switch. Src Remote VLAN The source VLAN is configured at the destination switch. If the remote VLAN is not configured, this field is blank. Dst Remote VLAN The destination VLAN is configured at the source switch. If the remote VLAN is not configured, this field is blank. IP ACL The IP access-list id or name attached to the port mirroring session. MAC ACL The MAC access-list name attached to the port mirroring session. show vlan remote-span This command displays the configured RSPAN VLAN. Format Mode show vlan remote-span Privileged Exec Mode Command example: (NETGEAR Switch)# show vlan remote-span Remote SPAN VLAN 100 Static MAC Filtering Commands The commands in this section describe how to configure static MAC filtering. Static MAC filtering allows you to configure destination ports for a static multicast MAC filter irrespective of the platform. macfilter This command adds a static MAC filter entry for the MAC address macaddr on the VLAN vlanid. A packet with a specific destination MAC address in a specific VLAN is admitted only if the ingress port is defined in the set of source ports, otherwise the packet is dropped. On the egress side, a packet that was admitted is sent through all ports that are defined in the set of destination ports. Switching Commands 524 CLI Command Reference Manual