Netgear XSM4324FS CLI Manual Software Version 12.x - Page 596
Port Security Commands
View all Netgear XSM4324FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 596 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches Command example: (Netgear Switch) #show mldsnooping proxy-querier Admin Mode Enable Interfaces Enabled for MLD Proxy Querier....... 1/0/1 1/0/2 1/0/3 Port Security Commands This section describes the command you use to configure Port Security on the switch. Port security, which is also known as port MAC locking, allows you to secure the network by locking allowable MAC addresses on a given port. Packets with a matching source MAC address are forwarded normally, and all other packets are discarded. Note: To enable the SNMP trap specific to port security, see snmp-server enable traps violation on page 129. port-security This command enables port locking on an interface, a range of interfaces, or at the system level. Default Format Mode disabled port-security Global Config (to enable port locking globally) Interface Config (to enable port locking on an interface or range of interfaces) no port-security This command disables port locking for one (Interface Config) or all (Global Config) ports. Format Mode no port-security Global Config Interface Config Switching Commands 596 CLI Command Reference Manual