Netgear XSM4324FS CLI Manual Software Version 12.x - Page 208

M4300 Intelligent Edge Series Fully Managed Stackable Switches The following information displays if you enter the count parameter. Term Definition Dynamic Address Number of MAC addresses in the forwarding database that were automatically learned. count Static Address (User-defined) count Number of MAC addresses in the forwarding database that were manually entered by a user. Total MAC Number of MAC addresses currently in the forwarding database. Addresses in use Total MAC Addresses available Number of MAC addresses the forwarding database can handle. process cpu threshold Use this command to configure the CPU utilization thresholds. The Rising and Falling thresholds are specified as a percentage of CPU resources. The utilization monitoring time period can be configured from 5 seconds to 86400 seconds in multiples of 5 seconds. The CPU utilization threshold configuration is saved across a switch reboot. Configuring the falling utilization threshold is optional. If the falling CPU utilization parameters are not configured, then they take the same value as the rising CPU utilization parameters. Format Mode process cpu threshold type total rising threshold interval seconds [falling threshold interval seconds] Global Config Term Description rising threshold The percentage of CPU resources that, when exceeded for the configured rising interval, triggers a notification. The range is 1 to 100. The default is 0 (disabled). rising interval seconds The duration of the CPU rising threshold violation, in seconds, that must be met to trigger a notification. The range is 5 to 86400. The default is 0 (disabled). falling threshold The percentage of CPU resources that, when usage falls below this level for the configured interval, triggers a notification. The range is 1 to 100. The default is 0 (disabled). A notification is triggered when the total CPU utilization falls below this level for a configured period of time. The falling utilization threshold notification is made only if a rising threshold notification was previously done. The falling utilization threshold must always be equal or less than the rising threshold value. The CLI does not allow setting the falling threshold to be greater than the rising threshold. falling interval seconds The duration of the CPU falling threshold, in seconds, that must be met to trigger a notification. The range is 5 to 86400. The default is 0 (disabled). Utility Commands 208 CLI Command Reference Manual