Netgear XSM4324FS CLI Manual Software Version 12.x - Page 1011
Multicast Commands
View all Netgear XSM4324FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1011 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches Multicast Commands This section describes the commands you use to configure IP Multicast and to view IP Multicast settings and statistics. ip mcast boundary This command adds an administrative scope multicast boundary specified by groupipaddr and mask for which this multicast administrative boundary is applicable. groupipaddr is a group IP address and mask is a group IP mask. This command can be used to configure a single interface or a range of interfaces. Format Mode ip mcast boundary groupipaddr mask Interface Config no ip mcast boundary This command deletes an administrative scope multicast boundary specified by groupipaddr and mask for which this multicast administrative boundary is applicable. groupipaddr is a group IP address and mask is a group IP mask. Format Mode no ip mcast boundary groupipaddr mask Interface Config ip mroute This command configures an IPv4 multicast static route for a source. Default Format Mode No MRoute is configured on the system. ip mroute src-ip-addr src-mask rpf-addr preference Global Config Parameter src-ip-addr src-mask rpf-ip-addr preference Description The IP address of the multicast source network. The IP mask of the multicast data source. The IP address of the RPF next-hop router toward the source. The administrative distance for this Static MRoute, that is, the preference value. The range is 1 to 255. IP Multicast Commands 1011 CLI Command Reference Manual