Netgear XSM4324FS CLI Manual Software Version 12.x - Page 378
Port Configuration for the Third-Party TPM404H HDMI Port Card, show slot, show port
View all Netgear XSM4324FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 378 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches show interfaces hardware profile This command displays the hardware profile information for the ports that support the expandable port feature. The command displays the 40G ports and the corresponding 10G ports. As an option, you can specify an interface. Format Mode show interfaces hardware profile [interface] Privileged EXEC Port Configuration for the Third-Party TPM404H HDMI Port Card Model M4300-96X running release 12.0.8.15 or a later release supports the third-party TPM404H HDMI port card. This port card provides four HDMI ports that are mapped to four 10G ports in the M4300-96X chassis. The HDMI ports are input ports, which means that they convert an incoming HDMI signal to Ethernet frames. The Ethernet frames are then forwarded like any other Ethernet frame in the switch. Because of thermal restrictions, you can install a TPM404H HDMI port card only in the upper slots (1-6) of the M4300-96X chassis. If you install the port card in a lower slot (7-12), the following occurs: • The following error message shows on the console and a similar message is also generated and logged in buffered logs: TPM404H card can only be installed in the slots on the top row. • The port card is neither programmed nor initialized. • The port card remains nonfunctional and does not show in the output of the show slot command. In the output of the show port command, the link state for the TPM404H HDMI port card shows as Up, even if the HDMI cable is not connected. The output of the show port command also shows that the physical mode and physical status of an HDMI port are set to 10G Full (for full duplex), and autonegotiation is not enabled. If you try to configure a different speed for an HDMI port or enable autonegotiation, an error is generated. The following example shows the output of the show port command when a TPM404H HDMI port card is installed in slot 5 of the M4300-96X chassis: (M4300-96X) #show port 1/5/1-1/5/4 Admin Physical Physical Link Link LACP Flow Stack Intf Type Mode Mode Status Status Trap Mode Mode Capable 1/5/1 Enable 10G Full 10G Full Up Enable Enable Disable Yes 1/5/2 Enable 10G Full 10G Full Up Enable Enable Disable Yes 1/5/3 Enable 10G Full 10G Full Up Enable Enable Disable Yes 1/5/4 Enable 10G Full 10G Full Up Enable Enable Disable Yes Switching Commands 378 CLI Command Reference Manual