Netgear XSM4324FS CLI Manual Software Version 12.x - Page 672

M4300 Intelligent Edge Series Fully Managed Stackable Switches Term Description Split Horizon Mode Whether RIP advertises routes on the interface on which the routes are received. Default Metric The metric assigned to redistributed routes. Default Route Advertise Whether the switch is originating a default route. Distance The administrative distance for RIP routes. Redistribution A table showing information for each source protocol (connected, static, and OSPF). For each of these sources, the distribution list and metric are shown. Fields that are not configured are left blank. For OSPF, the configured OSPF match parameters are also displayed. Interface The interfaces on which RIP is enabled and the version that is sent and accepted on each interface. Command example: (Router) #show ip protocols Routing Protocol OSPFv2 Router ID 6.6.6.6 OSPF Admin Mode Enable Maximum Paths 32 Routing for Networks 172.24.0.0 0.0.255.255 area 0 10.0.0.0 0.255.255.255 area 1 192.168.75.0 0.0.0.255 area 2 Distance Intra 110 Inter 110 Ext 110 Default Route Advertise Disabled Always FALSE Metric Not configured Metric Type External Type 2 Redist Source Metric Metric Type Subnets Dist List ----------- static default 2 Yes None connected 10 2 Yes 1 Number of Active Areas 3 (3 normal, 0 stub, 0 nssa) ABR Status Yes ASBR Status Yes Routing Protocol RIP RIP Admin Mode Enable Split Horizon Mode Simple Default Metric Not configured Default Route Advertise Disable Distance 120 Routing Commands 672 CLI Command Reference Manual