Netgear XSM4324FS CLI Manual Software Version 12.x - Page 876
ipv6 ospf link-lsa-suppression, ipv6 ospf mtu-ignore
View all Netgear XSM4324FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 876 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches value for the length of time must be the same for all routers attached to a network. A valid value for seconds is in the range from 1 to 65535. Default Format Mode 10 ipv6 ospf hello-interval seconds Interface Config no ipv6 ospf hello-interval This command sets the default OSPF hello interval for the specified interface. Format Mode no ipv6 ospf hello-interval Interface Config ipv6 ospf link-lsa-suppression Use this command to enable Link LSA Suppression on an interface. When Link LSA Suppression is enabled on a point-to-point (P2P) interface, no Link LSA protocol packets are originated (transmitted) on the interface. This configuration does not apply to non-P2P interfaces. Default Format Mode False ipv6 ospf link-lsa-suppression Privileged EXEC no ipv6 ospf link-lsa-suppression This command returns Link LSA Suppression for the interface to disabled. When Link LSA Suppression is disabled, Link LSA protocol packets are originated (transmitted) on the P2P interface. Format Mode no ipv6 ospf link-lsa-suppression Privileged EXEC ipv6 ospf mtu-ignore This command disables OSPF maximum transmission unit (MTU) mismatch detection on an interface or range of interfaces. OSPF Database Description packets specify the size of the largest IP packet that can be sent without fragmentation on the interface. When a router receives a Database Description packet, it examines the MTU advertised by the neighbor. By IPv6 Commands 876 CLI Command Reference Manual