Netgear XSM4324FS CLI Manual Software Version 12.x - Page 240

M4300 Intelligent Edge Series Fully Managed Stackable Switches 3 172.31.0.9 277 msec 276 msec 277 msec 4 10.254.1.1 289 msec 327 msec 282 msec 5 10.254.21.2 287 msec 293 msec 296 msec 6 192.168.76.2 290 msec 291 msec 289 msec 7 0.0.0.0 0 msec * Hop Count = 6 Last TTL = 7 Test attempt = 19 Test Success = 18 Command example: The following example shows that the IPv6 traceroute fails: (NETGEAR Switch)# traceroute 2001::2 initTtl 1 maxFail 0 interval 1 count 3 port 33434 size 43 Traceroute to 2001::2 hops max 43 byte packets: 1 3001::1 708 msec 41 msec 11 msec 2 4001::2 250 msec 200 msec 193 msec 3 5001::3 289 msec 313 msec 278 msec 4 6001::4 651 msec 41 msec 270 msec 5 0 0 msec * Hop Count = 4 Last TTL = 5 Test attempt = 1 Test Success = 0 clear config This command resets the configuration to the factory defaults without powering off the switch. When you issue this command, a prompt appears to confirm that the reset should proceed. When you enter y, you automatically reset the current configuration on the switch to the default values. It does not reset the switch. Format Mode clear config Privileged EXEC clear counters This command clears the statistics for a specified unit/slot/port, for all ports, for a specified VLAN, for a specified LAG, or for the entire switch based on the argument. Format Mode clear counters {unit/slot/port | all | vlan vlan-id | lag lag-intf-num} Privileged EXEC Utility Commands 240 CLI Command Reference Manual