Netgear XSM4324FS CLI Manual Software Version 12.x - Page 403
show spanning-tree interface, specify the LAG interface, in which
View all Netgear XSM4324FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 403 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches Command example: (NETGEAR Switch) #show spanning-tree brief Bridge Priority 32768 Bridge Identifier 80:00:00:10:18:48:FC:07 Bridge Max Age 20 Bridge Max Hops 20 Bridge Hello Time 2 Bridge Forward Delay 15 Bridge Hold Time 6 show spanning-tree interface This command displays the settings and parameters for a specific switch port within the common and internal spanning tree. The unit/slot/port is the desired switch port. Instead of unit/slot/port, lag lag-intf-num can be used as an alternate way to specify the LAG interface, in which lag-intf-num is the LAG port number. The following details are displayed on execution of the command. Format Mode show spanning-tree interface [unit/slot/port | lag lag-intf-num] Privileged EXEC User EXEC Term Definition Hello Time Admin hello time for this port. Port Mode Enabled or disabled. BPDU Guard Effect Enabled or disabled. Root Guard Enabled or disabled. Loop Guard Enabled or disabled. TCN Guard Enable or disable the propagation of received topology change notifications and topology changes to other ports. BPDU Filter Mode Enabled or disabled. BPDU Flood Mode Enabled or disabled. Auto Edge To enable or disable the feature that causes a port that has not seen a BPDU for edge delay time, to become an edge port and transition to forwarding faster. Port Up Time Since Time since port was reset, displayed in days, hours, minutes, and seconds. Counters Last Cleared STP BPDUs Transmitted Spanning Tree Protocol Bridge Protocol Data Units sent. Switching Commands 403 CLI Command Reference Manual