Netgear XSM4324FS CLI Manual Software Version 12.x - Page 511
interface lag, port-channel static, port lacpmode, Partner's System ID.
View all Netgear XSM4324FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 511 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches no lacp partner system priority Use this command to configure the default administrative value of priority associated with the Partner's System ID. Format Mode no lacp partner system priority Interface Config interface lag Use this command to enter Interface configuration mode for the specified LAG. Format Mode interface lag lag-interface-number Global Config port-channel static This command enables the static mode on a port-channel (LAG) interface or range of interfaces. By default the static mode for a new port-channel is enabled, which means the port-channel is static. If the maximum number of allowable dynamic port-channels are already present in the system, the static mode for a new port-channel is enabled, which means the port-channel is static. You can only use this command on port-channel interfaces. Default Format Mode Disabled port-channel static Interface Config no port-channel static This command sets the static mode on a particular port-channel (LAG) interface to the default value. This command will be executed only for interfaces of type port-channel (LAG). Format Mode no port-channel static Interface Config port lacpmode This command enables Link Aggregation Control Protocol (LACP) on a port or range of ports. Default Format Mode Enabled port lacpmode Interface Config Switching Commands 511 CLI Command Reference Manual